RLC-metru 100 Hz..10 kHz TTi LCR400

• Wide voltage and current range, 0 to 80 V and 0 to 80 A
• 300 watts continuous dissipation at 40 degrees C
• Versatile solution for testing dc power sources

 

• 10MHz D.D.S. function with arbitrary
• 0.1mHz to 10MHz range
• 7 digit resolution

 

• Provides an EN61000-3-2 compliant source
• 1000W power capability at 230V
• Up to 4·4A rms load current and up to 10A peak currents

 

• 0.1Hz to 10MHz frequency range
• Independent control of pulse frequency, width and delay
• 50ns minimum pulse width
• Squarewave, double pulse & delayed pulse modes
• Free-run, gated and triggered modes
• 50 Ohm output: 0.1V to 10V amplitude

 

• 16 MHz sine and square
• Single channel
• 40 MSa/s sample rate
• 12-bit vertical resolution

 

• High power 35V/10A & 18V/20A
• Compact & lightweight high power units
• Bench or rack mounting, front & rear terminals
• Very low noise, excellent transient response

 

• 10 MHz ..18.5GHz bandwidth
• Measurement range from -50 dBm to +20 dBm
• Replacement solution for conventional power meter and sensor combination
• Simple USB connection to laptop or PC
• Use multiple sensors on one laptop or PC

 

• 1 µHz to 50 MHz range(sine and square)
• 1 µHz resolution
• 128K points at up to 125MS/s Arbitrary waveforms
• True pulse generator with variable delay and variable rise/fall

 

• Up to 60 volts and up to 50 amps maximum
• PowerFlex design gives variable voltage & current combinations
• Higher current capability at lower voltages

 

• 1MHz to 1300MHz frequency range
• Resolution bandwidths of 1MHz, 280kHz or 15kHz
• -96dBm typical noise floor at -20dBm reference level
• Measurement in dBm or dBµV, mV or µW
• Zero span mode with AM and FM audio demodulation