RLC-metru de laborator 20Hz..5MHz Gw Instek LCR-8105G
PRODUS OBSOLET ( * SCOS DIN UZ )

Cod: Gw Instek LCR-8105G LCR8105G


 

Alte produse GW INSTEK

OSCILOSCOP ANALOGIC 2 X 100 MHZ GW INSTEK GOS-6112

• 100 MHz bandwidth, Delayed Sweep
• 2 analog channels
• Cursor Readout with 7 Measurements

 

GOODWILL INSTEK LCR-6000 SERIES

• Consecutive test frequency
• Basic accuracy : 0.05%
• Measuring speed up to 25ms (max.)
• Full frequency range or spot OPEN/SHORT

 

GOODWILL INSTEK AFG-303X SERIES

• Input/output signal ground independent of housing and signal ground between channels also insulated.
• Synchronized phase operates up to 6 units and 12 channels
• Pulse waveform parameters can be set independently for more precise timing
• Harmonic signal generator

 

GOODWILL INSTEK PPH-1503

• High Measurement REsolution (1mV/0.1mA for 5A Range);(1mV/0.1uA for
• 5mA Range)
• EXternal Relay Control Output On/Off
• Sink Current Capability (Maximum:2A)
• Digital Panel Control

 

GOODWILL INSTEK PPE-3323

• 50 Sets memory
• Self test and software calibration
• Meets UL, CSA, IEC safety regulation
• Auto step running with timer setting

 

GOODWILL INSTEK PEL-3000E

• OCP?OPP test Automation
• Max. Slew Rate: 2.5A/us
• Dynamic mode
• Protection: OVP, OCP, OPP, OTP, RVP, UVP
• Remote Sense

 

GOODWILL INSTEK GPC-SERIES

• Auto Series and Parallel Operation
• Constant Voltage and Constant Current Operation
• Low Ripple and Noise
• Internal Select for Continuous or Dynamic Load

 

TESTER RIGIDITATE DIELECTRICA GW-INSTEK GPT-9901A GPT-9902A GPT-9903 GPT-9904

• 500VA AC Test Capacity
• 240x64 Ice Blue Dot matrix LCD
• Sweep Function for DUT characteristic analysis
• Insulation resistance measurement up to 50GO(GPT-9903/9904)
• Manual/Auto Mode
• Interface : RS-232C, USB device, Signal I/O and GPIB (optional)

 

GOODWILL INSTEK GPR-U SERIES

• 0.01% High Regulation
• Constant Voltage and Constant Current Operation
• Low Ripple and Noise
• Overload and Reverse Polarity Protection

 

GOODWILL INSTEK GPR-H SERIES

• 0.01% High Regulation
• Constant Voltage and Constant Current Operation
• Internal Select for Continuous or Dynamic Load
• Low Ripple and Noise