The EX810 Clamp meter features a built-in IR thermometer with laser pointer for non-contact surface measurements from -58 to 518 degrees Fahrenheit (-50 to 270 degrees Celsius). Clamp measures AC current up to 1000 Amp with a maximum resolution of 0.1 Amp. The 1.7 in. jaw fits around conductors up to 750MCM. Peak hold captures motor inrush currents and other surges. Data hold and auto power off functions. Other features include AC/DC voltage, resistance, capacitance and frequency. Complete with test leads, 9 Volt battery and case.

� Non-contact InfraRed Temperature measurements with laser pointer

� Peak hold captures inrush currents and Transients

� MultiMeter functions include AC/DC Voltage, AC Current, Resistance, Capacitance, Frequency, Diode, and Continuity

� 1.7" (43mm) jaw opening for conductors up to 750MCM or two 500MCM

� 4000 count backlit display

� Autoranging with manual range button

� Features include Data Hold and Min/Max, Auto Power off

� Complete with test leads, 9V battery and case

Alte produse EXTECH

EXTECH EN100 TESTER PARAMETRI MEDIU MULTIFUNTIONAL 11-IN-1

• Built-in sensors measure Air Velocity, Air Flow, Temperature, Humidity, Wet Bulb, Dew Point, Heat Index, Wind Chill, Barometric Pressure, Altitude, and Light
• Field replaceable low friction vane wheel improves air velocity accuracy
• Backlit LCD display (auto off after 5 seconds)
• Data Hold, Auto Power Off, Auto-rotating display depending on function
• Complete with built-in multiparameter sensors, wrist strap, and CR2032 battery

EXTECH CT20 TESTER CONTINUITATE

• A bright flashing LED and loud pulsating beeper indicate local continuity
• Remote continuity with the use of the remote probe
• Flashing remote probe - two lead, bi-color (red/green) LED probe allows a single user to identify up to three wires or cables at a time
• Lightweight and pocketsized, clips on and hangs from the cable(s) under test without falling off
• Great for Electricians and Helpers, Cable TV and Audio System Installers, Alarm Technicians, Plumbers, HVAC Installers etc.

EXTECH 380820 SURSA UNIVERSALA AC SI ANALIZOR PUTERE

• 99 memory locations for preset voltage and frequency output settings
• User-programmable Over Current Protection
• Programmable through the built-in RS-232 interface
• Data acquisition mode captures readings to your PC with a user-programmable sampling rate of 2 to 65,535 seconds
• Complete with AC power cord, RS-232 to USB cable and software

EXTECH LCR200 RLC-METRU PORTABIL

• Measures Inductance, Capacitance, and Resistance with secondary parameter Q (Quality), D (Dissipation), R (Resistance), P (Phase), ESR (Equivalent Series Resistance)
• Simultaneous 20,000/2,000 count backlit display of the primary parameter (L, C or R) with the secondary parameter
• Auto Select measurement function with 1kHz default test frequency
• Five test frequencies
• Set Hi/Lo limits using absolute values or percentage limits

DINAMOMETRU MASURARE FORTA CU DATALOGGING EXTECH 475040-SD

• Features 5000g, 176 oz. and 49 Newtons measurement capacity
• Large dual backlit LCD with reversible display feature to match viewing angle
• Record data on SD card
• Updates reading every 0.2 seconds and sample rate is 1 second to 9 hours
• Integrated load cell measurement transducer

EXTECH 380260 MEGOHMMETRU DIGITAL CU AUTORANGING

• 250V, 500V, and 1000V test voltages
• Insulation Resistance to 2000MOhm
• Lo Ohm function for testing connections
• Lock Power On Function for hands-free operation

EXTECH EMF510 MULTIMETRU RADIATII ELECTRICE MAGNETICE

• Measure EMF/ELF levels in milliGauss (mG) or microTesla (µT) up to 2000mG (200µT) with two ranges to choose from
• Built-in single axis sensor provides basic accuracy reading of ±5%
• 30 to 300Hz bandwidth
• Backlit display to view in dimly lit areas
• Data Hold and Min/Max functions

EXTECH 407730 SONOMETRU DIGITAL

• ±2dB accuracy with 0.1dB resolution
• A+C weighting
• AC analog output
• Record Max/Min values over time
• Utilizes 0.5"(12.7mm) electret condenser microphone

EXTECH ET10 TESTER RECEPTACOL GFCI

• Works with GFCI circuits
• Tests for faulty wiring in 3-wire receptacles: Correct, Open Ground, Open Neutral, Open Hot, Hot/Ground Reverse, Hot/Neutral Reverse
• Lights indicate circuit condition
• Standard North American 3-prong plug

EXTECH DCP60-220 SURSA REGLABILA DE TENSIUNE 600W

•