The use of hydrogen detectors is a tried-and-tested method that can accurately locate even the tiniest leaks in drinking water mains.

A hydrogen mixture is pumped into the pipe via a hydrant or domestic connection and then escapes at the leak, where it can be precisely detected at the surface. Hydrogen is the lightest and cheapest of all trace gases. A mixture of 5% hydrogen and 95% nitrogen is used. This environmentally friendly gas mixture is neither combustible, toxic nor corrosive.

Because it reacts so accurately and quickly, the HL H2 is ideally for precisely locating even the smallest of leaks. Audible and visual displays help the user to find leaks. The probe can be quickly and easily removed from its carrying pole in order to locate leaks in enclosed spaces.

Benefits:

H₂ sensor that is insensitive to other gases
Audible and visual leak indication
No maintenance
Reading memory (histogram)
No saturation, fast recovery
Can be used as hand-held sensor

Standard accessories

Scope of delivery HL H2 Set

HL receiver

PAM H2 hydrogen sensor

VK 95 cable

Headphones

System case

Receiver strap

Operating manual

Recommended options

More products SEBAKMT

SEBA KMT VFL CR-20 VERY LOW FREQUENCY CABLE TESTING SYSTEM

• VLF Test System 20 kV
• high test capacity of 3 µF permits the simultaneous testing of all three phases
• method is officially recommended by the two VDE Standards 0276-620 and 0276-621
• VLF is the most economic method for testing PE and XLPE cables

SEBA KMT BT 500 IS-1 CABLE FAULT CONVERTER

• Overload protection
• Automatic discharge
• Burning of high resistive faults
• Low- potential free voltage avoids damage to other conductors
• Adjustable current limiter

SEBA KMT GEOLUX GL 660-1 EARTH FAULT LOCATOR FOR FAULT LOCATION IN ISOLATED, EARTH FREE SYSTEMS

• Earth fault locator for fault location in isolated, earth free systems
• Mains filter for direct coupling to live cables up to 660 V
• Pulsed output current for easier detection of the test signal
• Filter for the suppression large interference signals
• Location of earth faults up to 150 kOhm
• No switch off during the fault location required
• No influence to the signal lines connected to

SEBA KMT VCAM-5 SEWER PIPELINE VIDEO INSPECTION CAMERA

• One touch recording
• Lightweight and compact design
• Records to USB, SD or HDD
• JPEG still image capture
• Wi-Fi and Ethernet interface

SEBA SURGEFLEX SFX 8-1000 CABLE FAULT LOCATING SYSTEM

• Small, light and portable
• Very low voltage levels
• Complete fault location with DC Testing up to 8 kV
• Prelocation with ARM and ICE
• Burning with up to 1.4 A

SEBA KMT FERROLUX FLE 10 AUDIO FREQUENCY RECEIVER FOR CABLE LOCATION, SELECTION, SHEATH FAULTS

• Precise direction guidance with right/left arrows
• "SignalSelect" for clear route location
• Depth and signal current intensity measurement at the push of a button
• Route sensor weighs less than 1 kg for non-tiring use
• "DirectSignal" for effective line location

SEBA KMT VIVAX METROTECH VLOC2 LINE LOCATION AND TRACER FOR UNDERGROUND PIPES AND CABLES

• Carbon-reinforced plastic housing
• Protection class IP 54 for use in any weather conditions
• Colour display
• High-speed processor
• Several location modes with orientation using a compass
• A large number of available frequencies
• Depth/amperage at the press of a button or sustained

SEBA KMT KMK 8 COMMUNICATIONS NETWORK CABLE TESTER

• Integrated Reflectometer (TDR)
• Active bridge for high precision R and C measurements and DC and AC fault location
• Measurement by Graaf method in connection with an active slave at the far end
• Passive Wheatstone bridge for R and C measurements and DC and AC fault location
• Test Systems for Pre-measurement, Quick test and Quality testing
• Measurement of interference voltages
• Warning and information system
• Remote control for the operation of the electronic far end loop control switch

SEBA KMT T99/1 40KV DC HIGH VOLTAGE TEST UNIT

• generate a DC voltage of up to 40 kV
• Ideal for field application because of its low weight and compact design
• High safety due to internal discharge facility
• High flexibility with the external battery
• Over-current tripping

SEBA KMT HPG 50..80-D DC & AC HIGH VOLTAGE CABLE TESTER

• HPG 50-D, AC testing up to 35 kVRMS/ DC testing up to 100 kV
• HPG 70 / 80-D, AC testing up to 50 / 58 kVRMS / DC testing up to 140 / 150 kV
• Suitable for AC testing and DC testing
• Compact, cast-resin high-voltage transformers
• Separate control and HV-units
• Voltage continuously adjustable
• Powerful system: 1,2 kVA continuous operation, up to 3 kVA 60 min. short-time operation

Seba KMT Hydrolux HL H2 Hydrogen Leak DetectorOBSOLET PRODUCT ( * OUT OF USE )

Seba KMT Hydrolux HL H2 Hydrogen Leak Detector
OBSOLET PRODUCT ( * OUT OF USE )