The MA140 is a Compact AC Clamp Meter with NCV Detector. This Clamp meter takes True RMS measurements for accurate readings of noisy, distorted or non-sinusoidal waveforms. The MA140 can measure up to 300A AC. Complete with carrying case and two LR44 batteries. UL listed with a CAT III 600V safety rating.

� True RMS for accurate readings of noisy, distorted or non-sinusoidal waveforms

� Compact 0.8" (22mm) jaw size accommodates conductors up to 300MCM and allows measurements in tight locations

� Unique Smart Auto Sense feature

� Low Pass Filter (LPF) for accurate measurement of variable frequency drive signals

� Built-in Non-Contact Voltage (NCV) detector for quick detection of live voltage

� Inrush current measurement

� 6000 count backlit LCD display

� Smart Data Hold: Audiovisual alert when a new reading exceeds 50 digits of a held reading

� Low battery indicator and Auto Power Off feature

� Complete with carrying case and two LR44 batteries

More products EXTECH

EXTECH TG20 WIRE TRACER KIT

• Transmitter with output cables terminated in modular RJ11 phone connector
• Transmitter injects traceable signal into cables, checks telephone lines, and performs continuity checks
• Non-Contact probe audibly identifies selected wire or cable
• Easily trace wires from source to termination
• Test for properly operating phone lines

EXTECH PRT200 NON-CONTACT PHASE SEQUENCE TESTER

• 75 to 1000VAC input voltage with 45 to 65Hz frequency range
• LEDs indicate phase orientation (clockwise or counter-clockwise) and whether each phase is live
• Beeper sounds intermittently when correct phase is detected and continuously if phase is reversed
• Durable housing with back cover magnet for attachment to an AC distribution panel for easy measurement

EXTECH EA80 EASYVIEW™ INDOOR AIR QUALITY METER/DATALOGGER

• Checks for Carbon Dioxide (CO2) concentrations
• Maintenance free dual wavelength NDIR (non-dispersive infrared) CO2
• CO2 measurement range: 0 to 6,000ppm
• Temperature measurement range: -4 to 140°F (-20 to 60°C)
• Humidity measurement range: 10 to 95%RH

EXTECH HD780 DIGITAL MANIFOLD/PRESSURE GAUGE

• Dual differential inputs for pressure and temperature
• Displays 5 types of pressure units
• For use with R22 and R410A refrigerants
• Standard 1/4 NPT male flare fittings

EXTECH EN150 11-IN-1 ENVIRONMENTAL METER WITH UV

• Built-in sensors measure Air Velocity, Air Flow, Temperature, Humidity, Wet Bulb, Dew Point, Heat Index, Wind Chill, Barometric Pressure, Altitude, and UV Light
• Field replaceable low friction vane wheel improves air velocity accuracy
• Backlit LCD display (auto off after 5 seconds)
• Data Hold, Auto Power Off
• Complete with built-in multiparameter sensors, wrist strap, and CR2032 battery

EXTECH MP530A MULTIPRO® HIGH-PERFORMANCE MULTIMETER

• High basic DC Voltage accuracy of 0.08%
• Wide AC Voltage bandwidth of 40Hz to 20kHz
• Rugged design with protective holster and water resistant housing
• Backlit 5000 count LCD display for high resolution (0.01mV, 0.1µA, 0.01Ohm, 0.01nF, 0.001Hz)

EXTECH DM220 MINI POCKET MULTIMETER WITH NON-CONTACT VOLTAGE DETECTOR

• Large high contrast 4000 count LCD display
• Non-Contact Voltage detection identifies live circuits
• Built-in Flashlight
• Measures AC/DC Voltage, AC/DC Current and Resistance, Frequency and Duty Cycle
• Diode Test and Continuity Beeper

EXTECH DCP42 160W SWITCHING POWER SUPPLY

• Constantly calculates and adjusts the Voltage and Current limit points according to available maximum power (160W)
• At maximum current (10A), voltage is limited to 16V
• At maximum voltage (42V), current is limited to 3.8A
• Dual action rotary encoder control with push knob for fine and coarse tuning

EXTECH LT40 LED LIGHT METER

• Measure white LED and Standard Lighting in Lux or Foot-Candle (Fc) units
• Built-in sensor with protective cover
• 4000 count LCD display
• Cosine and color corrected measurements
• Min/Max Average and Auto Power Off
• Complete with 2 AAA batteries, and pouch

EXTECH EX810 1000A AC CLAMP METER WITH IR THERMOMETER

• Non-contact InfraRed Temperature measurements with laser pointer
• Peak hold captures inrush currents and Transients
• MultiMeter functions include AC/DC Voltage, AC Current, Resistance, Capacitance, Frequency, Diode, and Continuity
• 1.7" (43mm) jaw opening for conductors up to 750MCM or two 500MCM
• 4000 count backlit display
• Autoranging with manual range button