Ubiquitous Sensor Network Trainer ED-3160

Code: ED-3160


 

Datasheet PDF, 1.62 Mb

Description

EXPERIMENTS

  • Overview of the sensor network
  • Understanding of the sensor network hardware
  • Sensor network development environment build
  • Sensor network configuration method
  • Data transmission among ZigBee modules using the sensor network
  • Description of each sensor supplied in the equipment
  • ZigBee module and programming of the sensor control program
  • Sensor data collection using the sensor network
  • Usage and programming knowledge of the PC monitoring software
  • Sensor control using the PC monitoring software

 

Sensors:

  • Illumination Sensor -  Lux Meter and Photo Alarm Experiments
  • Magnetic Sensor - Magnetic Flux Meter, Tachometer, Speed Meter Experiments
  • Temperature Sensor - Thermometer Experiments
  • Humidity Sensor - Hygrometer Experiments
  • Pyroelectric Sensor - Human Body Detection Sensor
  • Ultrasonic Wave Sensor
  • Sound Sensor - Sound Detection
  • Pressure Sensor - Atmospheric Pressure Measurement
  • GAS Sensor - Gas Measurement
  • RFID - RF Card Reader
  • Acceleration Sensor(2-axis) - Motion Sensing
  • Azimuth Sensor - Direction Sensing
  • PH Sensor - PH Density Measurement
  • GPS Sensor - Location Detection
  • Finger Print Sensor - Finger Print Sensing
  • Relay Module
  • Interface Module
 

More products ED

AM TRANSCEIVER TRAINER ED-3400

• HF band(3.5~12MHz)
• Transmitter and Receiver modules for each circuit stage
• Graphical latour of the block diagrams, plus LEDs and test points
• Covers Push-to-Talk and helps understand short wave communications

 

PULSE/DIGITAL COMMUNICATION TRAINER ED-2920

• Modularized by each communicarion type
• PAM, PTM, PCM, DPCM, ADPCM, LDM, ADM, Delta-sigma
• No need to have additional generators (built-in power supply and signal source)
• Can display the test point and measure signals using an oscilloscope

 

INVERTER MOTOR TRAINER ED-4304

• Practical training on inverter and 3-phase induction motor operations
• Control experiments using a PLC module (in use of D/A module)
• Feasible contact-type PLC control
• Carrying case type structure for convenient storage and mobility

 

SMALL DESKTOP TYPE PLC TRAINER ED-4260MD

• Small desk type structure for space optimization
• Built-in DC power supply for convenience
• Handy experiments on the basic and application programming commands
• Base structure capable of expansion by mounting the special modules

 

EMBEDDED SOFTWARE DESIGN PLATFORM ED-255EK

• Basic to advanced learning courses for Embedded Linux
• Intel PXA255(400MHz) high-performance microprocessor
• 6.4TFT LCD, Ethernet 2port, Serial 3port, PCMCIA/CF/MMC interfaces
• FPGA Chip(Altera Cyclone 120,000Gate) mounted for SoC experiments
• Reliable hardware and abundant experiment contents for programming

 

ELECTRONICS DEMONSTRATION SYSTEM ED-2300

• 24 Experimental Boards in two sections : (A) Semiconductor and (B) Electronic Circuit
• Experimental Board rack and board storage cabinet

 

INTELLIGENT ROBOT DEVELOPMENT KIT ED-7273

• Obstacle avoidance and autonomous traveling using eight ultrasonic sensors
• Various types of robot configuration by combining each module
• Remote control by the controller
• Precise operation by DC Servo Motor
• Flow chart based programming software

 

WOUND-ROTOR INDUCTION MOTOR/ DC GENERATOR MG-5213

• Load characteristics of shunt-wound and compound generators
• Generator’s speed and output by winding type
• Loss and efficiency comparisons by winding type

 

REFRIGERATION & AIR CONDITIONING DEMONSTRATOR ED-5820/ED-5840

• Easy-to-use demonstarator for principles of refrigeration/airconditioning
• Motor Compressor : Pison type
• Trouble shooting for pipe leakage

 

SERVO UNIT TRAINER ED-4270M

• Experiments on various types of special control unit
• Characteristics of Servo Motor and setup of Servo Driver
• Essential components in automation using a PLC position module
• 4mm banana jack to increase wiring capability