The 407910 is a Differential Pressure Manometer that measures to 29psi and displays results in 8 units of measure. Features include: zero function for offset measurements, Min/Max, Data Hold and Auto power off. Includes 2 quick-disconnect fittings, 9V battery, protective holster with stand, and case.

Features:

±29psi with 0.02psi resolution
8 selectable units of measure
Zero function for offset measurements
Data Hold, Auto power off, and Min/Max functions

Alte produse EXTECH

EXTECH ET38 TESTER TENSIUNE SI CONTINUATATE

• Voltage detection range: 12 to 300V AC
• Continuity tester
• LED light indicator
• Includes built-in screwdriver tip, pocket clip, and two button batteries

EXTECH RH25 PSIHROMETRU INDEX INCALZIRE

• Built-in multiparameter sensor measures Heat Index, Wet Bulb Globe Temperature (WBGT), Humidity, Ambient Temperature, Temperature, Dew Point and Wet Bulb
• User Programmable Heat Index/WBGT alarm
• MIn/Max/Average
• Data Hold, Auto Power Off with disable
• Complete with CR2032 battery

EXTECH EX430 MULTIMETRU PROFESIONAL CU 1 FUNCTII

• True RMS DMM with 11 functions and 0.3% basic accuracy
• AC/DC Voltage & Current, Resistance, Capacitance, Frequency, Temperature, Diode/Continuity, Duty Cycle
• Input fuse protection and mis-connection warning
• 20A max Current

EXTECH EX320 MULTIMETRU CU 8 FUNCTII SI DETECTOR TENSIUNE FARA CONTACT

• Autoranging DMM with 8 functions and 0.5% basic accuracy
• AC/DC Voltage & Current, Resistance, Diode/Continuity
• Built-in non-contact AC voltage detector (NCV) with red LED indicator and audible beeper
• Large-digit 2,000 count LCD display

EXTECH MA140 CLESTE DE CURENT TRUE RMS 300A AC

• True RMS for accurate readings of noisy, distorted or non-sinusoidal waveforms
• Compact 0.8" (22mm) jaw size accommodates conductors up to 300MCM and allows measurements in tight locations
• Unique Smart Auto Sense feature
• Low Pass Filter (LPF) for accurate measurement of variable frequency drive signals
• Built-in Non-Contact Voltage (NCV) detector for quick detection of live voltage
• Inrush current measurement

EXTECH MG320 MEGOHMMETRU CAT IV TESTER IZOLATIE/TRUE RMS

• Measure Insulation Resistance to 20GO
• 5 Test Voltage ranges
• Polarization Index (PI) and Dielectric Absorption Ratio measurements (DAR)
• Low Resistance measurement with Zero function
• Programmable Timer feature sets the duration of test

EXTECH CO15: CARBON MONOXIDE (CO) METER

• Dual LCD simultaneously displays Carbon Monoxide (CO) level and maximum CO reading taken from when the meter was powered on
• Long life electrochemical sensor
• Adjustable CO warning level at 25, 30, 35, 45, 50, 70, 100 and 200ppm (alarm is preset to 25ppm)
• Audible alarm when CO level reaches the warning set point level
• Choose from 3 calibration points: 0 (preset), 100, and 500ppm

EXTECH CO30: CO (CARBON MONOXIDE) MONITOR

• Alternately displays Carbon Monoxide (CO) concentration, Air Temperature, and Relative Humidity readings (cycles approximately every 6 seconds)
• Visible bright tri-colored (green, yellow, red) LED alarm indicator
• Adjustable audible alarm for readings exceeding one of the selected ranges: 25ppm, 30ppm, 35ppm, 50ppm, 100ppm or 200ppm
• ZERO Re-Calibration function
• Manual Temperature and Relative Humidity Compensation (adjustable)
• CO Calibration function in fresh air

EXTECH 380360 MEGOHMETRU DIGITAL

• Three test voltages of 250V, 500V and 1000V
• Insulation Resistance to 2000MOhm
• Safety Power Lock enables "hands free" operation for 3 minute test
• Automatic discharge when safety "Press to Test" button is released
• Continuity measurements to 200Ohm and Voltage to 600VAC

EXTECH CO10: CARBON MONOXIDE (CO) METER

• Easy to read 1999 count backlit displays CO levels from 0 to 1000ppm
• 1ppm resolution with ±5% or ±10ppm basic accuracy (whichever is greater)
• Utilizes a stabilized electrochemical gas specific (CO) fast response sensor
• Audible alarm starts at 35ppm
• Backlight for low light conditions