Fluke 700HTPK HydraulicTest Kit for Pressure Calibration

• Full-featured multimeter with built-in thermal imager
• 15 measurement functions including: AC voltage with low-pass filter, DC voltage, Resistance, Continuity, Capacitance, Diode test, Min/Max/Avg, AC current (with iFlex), Frequency
• Image resolution-80 x 60
• 3.5 in /8.89 cm color LCD screen
• CAT III 1000 V, CAT IV 600 V measurement category

 

• 400 Hz measurement
• Power inverter efficiency: Simultaneously measure AC output power and DC input power
• PowerWave data capture: Capture fast RMS data, show half-cycle and waveforms
• Energy loss calculator
• Troubleshoot real-time
• Highest safety rating in the industry
• Measure all three phases and neutral

 

• 4.5 digit
• 20,000 count resolution for precise measurements
• 0.05% basic accuracy
• True-rms ac voltage and current for accurate measurements on non linear signals
• Selectable filter for accurate voltage and frequency measurements on motor drives
• Built in thermometer lets you carry one less tool (TC probe included)

 

• 1 kHz test frequency
• 0.25% accuracy
• test signal level: 2V via 400O source

 

• Ability to measure up to 100 m (330 ft)
• Instant measurement with one-button operation.
• Easy targeting with bright laser.
• Quick calculation of area and volume.
• Easy addition and subtraction of measurements.

 

• Combine with any Fluke-700G Series Gauge, 1,000 psi range or greater, to make a complete pressure testing kit
• Generates pressure up to 10,000 psi range or greater, to make a complete pressure testing kit
• Connect the 700G Series gauge directly to the HTP-2 hand pump
• Includes 700HTH-1 hose kit and adapters for connecting to the pressure device to be tested
• Hard case protects pump and gauge and allows gauge to remain connected to the pump

 

• -200 to 800�C Range Measure / simulate RTD (Pt 100)
• 0 to 3200 O Range Measure / simulate resistance
• 0.1 O, 0.1 �C Resolution

 

• 3.5 digit
• 6000 count
• 0.5% accuracy
• VoltAlert™ technology for non-contact voltage detection
• AutoVolt automatic ac/dc voltage selection

 

• 70 V to 300 V Operating Voltage
• Fast and easy recording of voltage trends, dropouts, and power quality
• Continuous recording of all values with no gaps
• Flicker recording to EN 61000-4-15, individual harmonic and THD values
• Min, Max, and Average RMS values

• Measure key parameters on direct-on-line motors including torque, RPM, mechanical power and motor efficiency
• Perform dynamic motor analysis by plotting of motor derating factor against load according to NEMA/IEC guidelines
• Calculate mechanical power and efficiency without the need of mechanical sensors, just connect to the input conductors and you're ready to go
• Measure electrical power parameters such as voltage, current, power, apparent power, power factor, harmonic distortion and unbalance to identify characteristics that impact motor efficiency