Seba KMT VFL CR-60-HP Long Cables Test Systems
ROM
ENGHipot High Voltage Testers > SEBAKMT (19) > Seba KMT VFL CR-60-HP Long Cables Test Systems
Recommended products
Seba Teleflex VX Cable Reflectometer for fault location systems
Seba T18/5 Surge Wave Voltage Generator for Cable Fault Locating
Seba KMT Easytest 20kV VFL cable tester Very Low Frequency
Seba Teleflex T3060 Single-Phase Power Cable Reflectometer T 3060
Seba KMT VFL CR-60-HP Long Cables Test Systems
Code: Seba-KMT VLF CR-60-HP
Product Datasheet (*.PDF - 0.28 Mb)VLF CR-60-HP
Powerful 0.1 Hz VLF test system with energy recovery for testing of cables with Cosine Rectangular Wave voltage according to VDE, IEC and IEEE.
In accordance with most regulations, cables and joints must be tested after installation or repair. The Seba KMT VLF Test System CR 60 kV can be used to test cables with operating voltage levels up to 36 kV. The system consists of a control unit and a HV unit. The high test capacity of 6.5 μF permits the simultaneous testing of all three phases. Positive and negative DC testing of cables and connected switchgear can be carried by DC Mode.
This VLF Test System CR 60 kV can be used both as a stand alone system and as integrated part of a test van system.
Key Benefits:
- Very high test power without frequency reduction
- Covers cables up to 20 km @ maximum Voltage
- No polarisation effects as with DC
- Protocoling
- Breakdown detection
- Leakage current measurement
Options
Integrated Printer
HV cable drums manual or motor driven
LV connection cables
De-humidifi er VLF 60/80 kV*
Options
Integrated Printer
HV cable drums manual or motor driven
LV connection cables
De-humidifi er VLF 60/80 kV*
Copyright © 2010 - 2025 / Distek