Extech PRC10: Current Calibrator/Meter

• Measure white LED and Standard Lighting in Lux or Foot-Candle (Fc) units
• Built-in sensor with protective cover
• 4000 count LCD display
• Cosine and color corrected measurements
• Min/Max Average and Auto Power Off
• Complete with 2 AAA batteries, and pouch

 

• Checks phase sequence and phase status
• Tests up to 600VAC and displays graphical phase orientation on the large LCD
• Double molded durable housing
• Easy to use alligator clips with wide jaws

 

• Easy to read 1999 count backlit displays CO levels from 0 to 1000ppm
• 1ppm resolution with ±5% or ±10ppm basic accuracy (whichever is greater)
• Utilizes a stabilized electrochemical gas specific (CO) fast response sensor
• Audible alarm starts at 35ppm
• Backlight for low light conditions

 

• Adjustable Voltage and Current output
• Easy snap terminals for fixed 5V/0.5A and 12V/1A outputs
• Constant Voltage or Current
• Current limiting indicator
• Overload and short circuit protection
• Binding post terminals for variable supply

 

• Sensor wavelength range 320 to 390nm
• UV sensor with cosine correction measures irradiance from UVA light sources up to 20.00mW/cm²
• Backlit LCD to view in dimly lit areas
• Zero function
• Data Hold and Min/Max functions

 

• 6 ranges with 3 sub-ranges in each current range
• Measurement of resistive and inductive materials
• 5-Digit backlit LCD, PC interface
• Auto or Manual ranging, 10A maximum test current
• Store/Recall up to 3000 measurements

 

• Manual ranging multimeter with 2000 count display
• Built-in non-contact Voltage Detector for quick detection of live circuits
• AC/DC Voltage measures up to 500V
• Functions include AC/DC Voltage, DC Current, Resistance, and Diode Test
• Test the quality of 9V batteries

 

• Built-in Datalogger stores up to 1,012 readings (single record/continuous datalogging)
• Four simultaneous displays of Watts, Power Factor or VA, Voltage or Hz, Amps
• True RMS Voltage & Current measurements of sine, square, triangular and distorted wave forms with a crest factor < 5
• Plug device to be tested directly into the Power Analyzer

 

• Built-in sensors measure Air Velocity, Air Flow, Temperature, Humidity, Wet Bulb, Dew Point, Heat Index, Wind Chill, Barometric Pressure, Altitude, and UV Light
• Field replaceable low friction vane wheel improves air velocity accuracy
• Backlit LCD display (auto off after 5 seconds)
• Data Hold, Auto Power Off
• Complete with built-in multiparameter sensors, wrist strap, and CR2032 battery

 

• Quickly locate Circuit Breakers and Fuses
• Receptacle Tester (Transmitter): Test GFCI circuits, LED indication of 2 test conditions and 6 wiring faults, Test Reversed/Open Connections
• Complete with Receiver, Transmitter and 9V battery
• Microprocessor-based automatic sensitivity adjustment, Audible and visual indication, low battery indicator, Ergonomic design