The 380320 is an Analog Insulation Tester with a large, easy to read analog display. Featuring a live circuit warning which displays the actual AC voltage measurement, Automatic discharge circuit, Lock Power On feature for extended test times, and Insulation resistance up to 400MO. Complete with heavy duty test leads, alligator clip test lead, 6 x AA batteries, hanging strap and hard carrying case.

Features:

� Large easy to read analog display

� Three test voltages 250V, 500V, and 1000V

� Insulation Resistance to 400MOhm

� Lock Power On feature for extended test times

� Automatic discharge circuit

� Measures Continuity to 3Ohm, Resistance to 500Ohm, and AC Voltage to 600V

� Complete with heavy duty test leads, alligator clip test lead, 6 x AA batteries, hanging strap and hard carrying case

Alte produse EXTECH

EXTECH CO30: CO (CARBON MONOXIDE) MONITOR

• Alternately displays Carbon Monoxide (CO) concentration, Air Temperature, and Relative Humidity readings (cycles approximately every 6 seconds)
• Visible bright tri-colored (green, yellow, red) LED alarm indicator
• Adjustable audible alarm for readings exceeding one of the selected ranges: 25ppm, 30ppm, 35ppm, 50ppm, 100ppm or 200ppm
• ZERO Re-Calibration function
• Manual Temperature and Relative Humidity Compensation (adjustable)
• CO Calibration function in fresh air

TESTER UMIDITATE SOL EXTECH MO750 UMIDOMETRU HIGROMETRU

• Meter with Heavy-Duty 8" (20cm) Probe
• Soil moisture content measurement from 0 to 50%
• Easy one-hand operation
• Min/Max records minimum and maximum moisture readings
• Data hold to freeze reading on display
• Water resistant

EXTECH 480403 TESTER ROTATIE MOTOR SI SENS FAZE

• Indicates rotation direction of the motor
• Determine rotation of a motor without contact
• LEDs indicate phase orientation (clockwise or counter-clockwise) and whether each of the three phases is live
• Double molded durable housing
• Easy to use alligator clips with wide jaws

EXTECH ET38 TESTER TENSIUNE SI CONTINUATATE

• Voltage detection range: 12 to 300V AC
• Continuity tester
• LED light indicator
• Includes built-in screwdriver tip, pocket clip, and two button batteries

EXTECH PQ3350-3 ANALIZOR PUTERE SI ARMONICI 3 FAZE

• Datalogging of single and 3-phase/3-wire or 3-phase/4-wire systems (up to 52,428 single phase readings or 17,476 3-phase readings)
• Flexible clamp probes can be used for wrapping around bus bars and wire bundles
• Large backlighting LCD displays up to 35 parameters in one screen
• Clamp-on True RMS power measurements with on-screen Harmonics display
• Simultaneous display of Harmonics and Waveform

EXTECH 48VFL11 CONTROLER TEMPERATURA CU IESIRE RELEU

• One relay output
• Dual 4-digit LED displays of process and setpoint values
• User friendly menus and tactile keypad for easy programming
• One-touch autotuning for quick setup & precise control
• Fuzzy Logic PID offers intuitive control simulating human control logic

EXTECH MA150 CLESTE AMPERMETRIC 200A MINI AC CLAMP METER + DETECTOR FARA CONTACT

• 0.7" (18mm) jaw opening
• 2000 count backlit LCD display
• Non-contact AC Voltage detector (100 to 600VAC) via clamp tip
• Built-in white LED flashlight
• Continuity and Diode Test, Max Hold, Auto power off

EXTECH 380260 MEGOHMMETRU DIGITAL CU AUTORANGING

• 250V, 500V, and 1000V test voltages
• Insulation Resistance to 2000MOhm
• Lo Ohm function for testing connections
• Lock Power On Function for hands-free operation

EXTECH MN15A MINI-MULTIMETRU DIGITAL

• Large easy to read digital display
• AC/DC Voltage, DC Current, Resistance, Continuity, Diode Test and Type K Temperature
• 1.5V and 9V Battery test function
• Complete with 9V battery, general purpose Type K bead wire probe and test leads

EXTECH 380803 ANALIZOR PUTERE CU DATALOGGER

• Built-in Datalogger stores up to 1,012 readings (single record/continuous datalogging)
• Four simultaneous displays of Watts, Power Factor or VA, Voltage or Hz, Amps
• True RMS Voltage & Current measurements of sine, square, triangular and distorted wave forms with a crest factor < 5
• Plug device to be tested directly into the Power Analyzer