The LISN is inserted into the supply line of the DUT (Device Under Test). Conducted noise which is present at the supply terminals of the DUT can be measured at the BNC connector using a spectrum analyzer or a measurement receiver.

The source (supply) terminal and the DUT terminal are decoupled by a 5½H inductor.

Features:

Frequency range: 100kHz ½ 110MHz (1GHz, see figure 4 in the manual)
DC Resistance: 40 mO
Maximum current: 10A
Nominal operating voltage range: 0 ½ 60V DC *

More products TEKBOX

TEKBOX TBOH02 SELF POWERED ACTIVE LOAD

• Operating voltage range: 2V ½ 70V
• Maximum current: 10A
• Power rating: max. 25W continuously; with additional fan 100W continuously
• Ranges: 0A ½ 1A, 0A ½ 10A, 1O ½ 10O, 10O ½ 100O
• External voltage control input

TEKBOX TBST 120/60/60/2 SHIELDED TENT

• Outer dimensions: 120 cm x 60 cm x 60 cm
• Opening dimensions: 85 cm x 35 cm
• Frame: 20 mm x 20mm extruded aluminium profiles
• Shielding: 2 layers of conductive fabrics
• Seal: conductive Velcro tape

TEKBOX TBWA2/20DB, TBWA2/40DB RF AMPLIFIERS

• EMC probe amplifier
• General purpose wideband RF amplifier

TEKBOX TBPS01 EMC NEAR-FIELD PROBES + TBWA2 WIDEBAND AMPLIFIER

• Slim design for good access in between tightly spaced components
• Shielded loops to avoid picking up common mode noise; insensitive to the human hand
• Frequency range: up to 6GHz, see coupling plots of the respective probes
• SMB connectors to avoid twisting the RF cable when scanning DUTs

TEKBOX TBMR-110M EMI-ANALYZER 1 HZ-110 MHZ

• EMI Analyzer 1 Hz "" 110 MHz (Measurement Receiver)
• Spectrum Analyzer
• Tracking Analyzer 1 Hz "" 110 MHz
• Noise Analyzer 1 Hz "" 110 MHz
• Oscilloscope 250 MS/s, DC "" 110 MHz

TEKBOX TBHDR1 RF AMPLIFIER

• General purpose gain block
• Pre-amplifier in applications with low noise and high IP3 requirements
• Pre-amplifier for spectrum analyzers, especially in EMC pre-compliance test applications
• Loop antenna amplifier