Extech ET38 Voltage Continuity Tester

• Designed for professionals who routinely audit existing and replacement lighting systems for energy efficiency and lighting performance
• Kit includes:
• LT300 - Light meter with digital and analog display of light in Foot-candles or Lux
• DT200 - Compact laser distance meter with area/volume calculation functions
• 380940 - 400A True RMS AC/DC power clamp meter
• Supplied in a soft carrying case that provides protection and organization for the meters whenever they are needed

 

• High basic DC Voltage accuracy of 0.08%
• Wide AC Voltage bandwidth of 40Hz to 20kHz
• Rugged design with protective holster and water resistant housing
• Backlit 5000 count LCD display for high resolution (0.01mV, 0.1µA, 0.01Ohm, 0.01nF, 0.001Hz)

 

• Troubleshoot electrical/electronic circuits and identify up to 16 local or installed lines
• MultiMeter functions include: AC/DC Voltage and Current, Resistance, Diode, and Continuity
• Transmitter/Receiver enables one person to remotely identify up to 16 wires
• Wire voltage check from 5 to 16VDC
• Data Hold and Max Hold, Auto power off

 

• Sensor wavelength range 320 to 390nm
• UV sensor with cosine correction measures irradiance from UVA light sources up to 20.00mW/cm²
• Backlit LCD to view in dimly lit areas
• Zero function
• Data Hold and Min/Max functions

 

• True RMS for accurate AC measurements
• 4000 count backlit LCD display
• Low Impedance (LoZ) prevents false reading caused by ghost voltages
• Low Pass Filter (LPF) for accurate measurements of variable frequency drive signals

 

• Three test voltages of 250V, 500V and 1000V
• Insulation Resistance to 2000MOhm
• Safety Power Lock enables "hands free" operation for 3 minute test
• Automatic discharge when safety "Press to Test" button is released
• Continuity measurements to 200Ohm and Voltage to 600VAC

 

• Use on wall board, sheet rock, cardboard, plaster, concrete, and mortar
• Replaceable threaded measurement electrode pins
• Self-contained, pocket sized meter with belt clip

 

• True RMS for accurate AC measurements
• 6000 count backlit LCD display
• Low Impedance (LoZ) prevents false reading caused by ghost voltages
• Low Pass Filter (LPF) for accurate measurements of variable frequency drive signals

 

• Built-in IR Thermometer with laser pointer for locating hot spots (6:1 Distance to Target Ratio)
• AC/DC Voltage, AC/DC Current, Resistance, Capacitance, Frequency, Temperature (Type K + IR), Duty Cycle, Continuity / Diode
• 4000 count large backlit dual LCD with easy-to read digits
• Low current capability measure down to 0.1µA

 

• Simultaneous display of Pressure, Air Velocity or Air Flow plus Temperature
• ±0.7252psi range
• 5 selectable units of pressure measurement
• Max/Min/Avg recording and Relative time stamp
• Data Hold and Auto power off functions